Advanced Pressure Systems
701 S. Persimmon, Suite 85, Tomball, Texas 77375
Call Toll Free in North America 1 (877) 290-4277 or (281) 290-9950

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Hose Whip Restraints

APS strongly recommends the use of "hose whip restraint" in any water jetting operation. These are perhaps the simplest and least expensive safety measure to implement. A "hose whip restraint" can be attached at any point where two hoses are joined, or to a pump's fluid end at the discharge side, or where a hose attaches to any piece of water jetting equipment such as a waterjet lancing or cutting system. When a high pressure hose is joined to a piece of equipment, the hose whip restraint should be used to restrain the movement of the pressurized hose, should it become uncoupled, thereby allowing operators to get away and perform a safe, orderly system shut-down.


A
lways Providing Service


Pictured above are two typical hose whip restraint types: stainless steel tension model, and high-strength, brightly-colored nylon with rubber cinch bands.

 

Part Number
Description
43-010-001
Stainless Hose Whip Restraint
43-010-002
Nylon Hose Whip Restraint